Horsemen turnovers in the twentieth

by **mavr7325** on 13 Feb 2010, 20:58

Good day! Tell my, why? Idle speed gallop. niva, injector, 1,7. Forced into service, could not resolve. Rates probably are! Himself in the repair work are very few understand.

**AdSense**

by **MURTAZA** on 13 Feb 2010, 22:44

How much to jump? If not much (about 50 rpm), it gidrokompesatory and gidronatyazhitel can. If more, the wire, candles, distributor, and sensors.

by **a crocodile** on 14 Feb 2010, 21:22

I, too, plus minus 40 jump but that's OK

by **spoon** on 14 Feb 2010, 23:53

Check the throttle cable.
"If over-stretched cable will open the valve Vauxhall only 3%, in the understanding of EDMS is not a twentieth, and partial load - the control unit begins to correct the wrong process, turnover will be unstable. So the cable should be slightly slack." Journal "For Rulem" № 2 February

by **takh** on 28 Jul 2010, 23:37

Friends, help. I, too, galloping pace. Shniva 2005, took second-hand, I drive the second month. Sometimes it turns arbitrarily raised slightly above the thousands. What is the problem?

by **Wasilih** on 29 Jul 2010, 00:35

on the Volga River jumped from 900 to 1500 due to buggy temperature sensor ... When it set for 85, he gave the signal as if drygatel cold ... but the Volga, ETOGES UFO almost ...

by **GroveR** on 29 Jul 2010, 01:14

Check the throttle position sensor IMHO, and you will have good fortune :ok:

by **Sanya** on 29 Jul 2010, 08:04

Know how to injectors, but if speed carbo jump, and the car jerks, just blow through e-IAHS. valve.

by **Igyr** on 29 Jul 2010, 09:03

See the WMS where air drain. It was such a crap when the new, with only salon karbovoy soil. We went to the Black Sea, reached idle gallop. Remove the carb and drain the air. At izhektore xs WMS similarly otkudanibud with hose vakuumnika drain or elsewhere, after DMRV, that ECU does not know how to adjust it with the same probe lyamda else sees. Here is wrapped :roll:

by **takh** on 29 Jul 2010, 10:24

GroveR wrote: Check the throttle position sensor IMHO, and you will have happiness

So much so, and where is he?

by **Igyr** on 29 Jul 2010, 11:13

what throttle cable twists, then it is

I have to 10ke was, this sensor podtersya were failures when you gas. Well then a soldered board. Comp. it can be clearly seen, in%, opening the shutter. I had 0,1,2 ,---, 6,7 ....%

by **GroveR** on 01 Aug 2010, 23:47

takh wrote:
GroveR wrote: Check the throttle position sensor IMHO, and you will have happiness

So much so, and where is he?

Directly on the throttle